Does anyone have any experience with sealing plates? Or is it not worth it?
solidator
July 27, 2016 AT 8:27 am
better cut the crack
drummies
July 27, 2016 AT 8:27 am
how to say minicap, crack on bend
solidator
July 27, 2016 AT 8:28 am
difficult, but possible. Give to people with experience
drummies
July 27, 2016 AT 8:29 am
There are no such people in my village :(
solidator
July 27, 2016 AT 8:29 am
then get some experience yourself - there you have immediately what chance was given) Drill the holes at the ends of the crack, then use a milling cutter (or the same drill, but well sharpened, not old) to connect them. Grind with a file so that there are no sharp corners and transitions. And then try not to smoke in this place
lucky83
July 27, 2016 AT 8:30 am
From my experience, I can say that drilling, sawing, grinding and polishing even of very good quality does not solve the problem for long, despite the fact that you do not hit the defective spot at all
Ivan_drums
July 27, 2016 AT 8:30 am
but if there is a crack at the edge, then the cutout will help
solidator
better cut the crack
drummies
how to say minicap, crack on bend
solidator
difficult, but possible. Give to people with experience
drummies
There are no such people in my village :(
solidator
then get some experience yourself - there you have immediately what chance was given) Drill the holes at the ends of the crack, then use a milling cutter (or the same drill, but well sharpened, not old) to connect them. Grind with a file so that there are no sharp corners and transitions. And then try not to smoke in this place
lucky83
From my experience, I can say that drilling, sawing, grinding and polishing even of very good quality does not solve the problem for long, despite the fact that you do not hit the defective spot at all
Ivan_drums
but if there is a crack at the edge, then the cutout will help
kirill_an
If B20 then forget