sega
Hello everyone, how can I remove the high clap of the bass barrel? Plastic Evans Onyx, Evans resonance, diameter 20". Homemade from Amati. Beech.
The beater hits the center, the pedal is attached below the hoop through the delivery. Petal Pis, cardan. Tried Remo power sling 3, Pinstripe coated. Even worse. On Evans, smacking was the best way to catch the sound of a smack, and the cotton still can't be removed. Moreover, the barrel sounds good when unbalanced, if you fine-tune the bolts, the cotton increases.
a_sharapko
Firstly, I advise you to tune the bass drum with a tuner, and secondly, put a blanket / towel rolled up in a bag so that each of its ends touches the heads - this will subtitle them. Tuning the bass drum with a tuner will produce a smoother tone.
kreker
inside a light and fluffy padding pad
impact plastic ala impact III coated
rezo is best sprayed or fiberskin.
felt beater, the softer - the less click.
aroma
I have the same heads, only 22 "and I have no beech wood, well, I play only with a single pedal, respectively, my bass drum is completely empty, the" EMAD "damping system on the drum head does its job. in the mix it is not so “scary.” Since you are playing with a double pedal, you have to slightly mute it, as mentioned above, but because of this, the click is amplified. more tone .. Well, beaters ... as mentioned above.