insider
Hello everyone. Help the fool) I have such a thing as pearl eliminator 2002c. I bought a used one with a slightly patched one. In general, there is one moment with him that really soars me, but I don't have enough brains to figure it out myself. The previous owner filled all the cogs on it with a blue thread retainer. I tore off a few pieces from the retainer, but unfortunately I can't do the most important ones. How to tear off the retainer so as not to finish off the pedals completely?))
1sthast
Heat it up with a hair dryer
solidator
There is an old way for non-twisting elements: use a soldering iron to warm up your dowels and twist.
sega
This is not a previous owner, but a factory paste
swerus
thread clamps only to warm up, do not rip off just like that, you will completely doubt the heads.
plus it would be nice to tap the area around the screw
amdm
there is no use knocking, Loctite just prevents this, specifically blue, and in general any
red loctite reacts to heating (which is gray after solidification)
blue shouldn't react too much to heating, although I haven't tested it.
according to the instructions for Loctite, you just need to twist it abruptly enough to release the sealant itself.
but in order not to rip off the head of the screw, you need to choose a high-quality and durable key (not aluminum), which will sit in the head without backlash.
5seven
It is necessary to heat it, you can point it with a soldering iron.
kreker
The thread clamps are removed by heating with a point soldering iron, just don't try it, it's still a pedal, not a UAZ, you can break off the head or bend the part once or twice