RUEN

replacing the brains of the XM 100SR with a Yamaha DTX 700

solidator

Comrades, tell me, please. I have an XM 100SR electric hammer. There was an option to replace her brains with a Yamaha DTX 700 module. Are they supported by this installation? And in general, does it make sense to do so?) Unfortunately, it is almost impossible to buy the entire Yamaha DTX 700K setup at the present time)

  • swerus
    August 4, 2015 AT 10:45 pm

    In fact, electronic pads are an elastic band (or Kevlar) and a piezo bell with wiring. And which module to process the signal is already your choice.

    If in doubt, ask the module to test it, or somehow agree that if it suddenly does not grow together, you will return it

  • solidator
    August 4, 2015 AT 10:45 pm

    yes, I thought so too. But the problem is that the purchase is planned in another city) You will not be able to protest. You need to know for sure.

    Thanks for the answer.

  • runner
    August 4, 2015 AT 10:45 pm

    take one pad with you.

  • solidator
    August 4, 2015 AT 10:45 pm

    yes, that's exactly what you have to do. Thanks for the advice!